Morpheus

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Known Issues =====

==== Installation ====

=== Installation on Mac OSX ===

Please see the page on [[download:osx_10.8_users|troubleshooting for Mac]].

==== Simulation ====

=== ''Function'' gives erroneous values ===

''Function''s have been reported to generate erroneous values in the following situation:
  * ''Function'' is defined outside of ''System'' but used inside ''System'' (which is allowed) and
  * OpenMP multithreading is used (i.e. Settings/Local/Threads per jobs > 1).

Work around:
  * Drag ''Function'' inside the ''System''
  * Or, use only single thread per job.

==== Visualization ====

=== Gnuplot says "unknown or ambiguous terminal type" ===

Morpheus depends on [[http://www.gnuplot.info|Gnuplot]] version 4.4. Please update [[http://www.gnuplot.info|Gnuplot]]. \\ \\

In many cases, this error is due to the fact that the ''PDF'' and ''PNG'' terminals depend on ''libcairo''. As a workaround, one can use another terminal such as ''SVG'' or ''JPG''.

=== Gnuplotter on-screen output shows flickering ===

Some gnuplot terminals, such as Aquaterm in Mac OSX, are relatively slow and may show flickering when run under ''interactive'' mode.

As a workaround, do one of the following: 
  * In ''interactive'' mode: Use the screen terminal ''X11'' instead of ''aqua''. 
  * In ''local'' mode: Use a file terminal such as ''png'' and ''pdf''.

==== Report an issue ====

=== Found a bug? Send us a report. ===

If you experience reproducable crashes in a situation that is not covered here, please send us a [[joern.starruss@tu-dresden.de|bug report]]. \\

In the bug report, include as much information as possible, such as: \\

  - How to reproduce the bug
  - XML model that produced the error (if applicable)
  - Morpheus version/revision (see ''Settings -> Local -> Check Simulation -> Test'') 
  - Your operating system
  - Log file of the debugger (''gdb.log'')

==== GUI ====

=== Added item does not appear in Editor (tree view) ===

As a workaround, click on the element in the Document view. This will force updating the tree view.

=== Drag/dropping items in Editor mixes up subitems ===

As a workaround, click on the element in the Document view. This will force updating the tree view.

=== Some jobs continue despite stopping multiple jobs in ''JobQueue'' ===

If this occurs, you will need to remove the remaining jobs by selecting and removing them again. 

=== Simulation state [SnapShot].xml.gz cannot be restored (under Windows) ===

It has been reported that snapshots of simulation states, in compressed model files (''[SnapShot].xml.gz''), cannot be restored under Windows. This is most likely due to a corruption in file compression.

A solution or workaround has yet to be found.